ASME Y14.5-1994 Assumed 90 degree angle on the print

[JsTyLz]

Under the ASME Y14.5-1994 - Is there anything relating the appearance of all right angles as 90 degrees. I have been told that you must assume that all right angles are 90 degrees.

1. Is it true under the ASME standard I posted?

2. Furthermore, do you assume the title block tolerance on that 90 degree angle??


Thanks in advance

 

[KENAT]

Take a look to see if this answers your question thread1103-192522

KENAT, probably the least qualified checker you'll ever meet...

 

[powerhound]

Yes, fundamental rule 1.4(i) says this very thing, If you have a standard handy, it's on page 4. A more in-depth explanation is on 2.1.1.2 on page 23.

Powerhound
Production Supervisor
Inventor 11
Mastercam X2
Smartcam 11.1
SSG, U.S. Army
Taji, Iraq OIF II

 

[JsTyLz]

Thanks for the posts!! Thats all I needed