Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME UG45 Nozzle thickness when connected to flat plate

Status
Not open for further replies.
ksnar

ksnar

Mechanical
Joined
Jul 24, 2002
Messages
17
Location
NL
Can someone explain if the nozzle thickness when connected to a flat plate acc. UG-45(b)(1) should have the thickness of the plate? Isn't a smaller nozzle thickness allowed?
 
Sort by date Sort by votes
Ksnar UG-45
Make sure you read the entire paragraph.
 
Upvote 0 Downvote
Thanks, it's clear now.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Sajjad2164
  • Question Question
ASME VIII-1 Nozzle Spacing Clash
Replies
7
Views
11K
Si-bo
Si-bo
Gears6580
  • Locked
  • Question Question
Code calculations to determine the thickness of the flat plate to blank leaking tubes
Replies
3
Views
634
r6155
r6155
mariolucas75
  • Question Question
thickness tolerance of piping Vs plates
Replies
1
Views
6K
MJCronin
MJCronin
IdanPV
  • Locked
  • Question Question
Nozzle to Shell Weld
Replies
11
Views
5K
DekDee
DekDee
Vessel-SA
  • Question Question
nozzle-head PWHT
Replies
14
Views
15K
Trestala
Trestala

Part and Inventory Search

Sponsor

Back
Top