Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Asme stamp for Hrsg's visual report

Status
Not open for further replies.

Ozan Cil

Mechanical
Joined
Feb 10, 2017
Messages
1
Location
IQ
Dear sir,

When I prepare weld visual report for hrsg, I am writing only P11,P22, or P91 on the material type box at the visual report only for alloy steel pipes. I know only one material named of P11,P22 or P91 type. When we search P11,P22 or P91 at asme,we will see different composition smls pipe, in that case is it necessary mention SA number (SA335) before the P11,P22,P91 at the visual report, material box ? Wihout SA number of reports for HRSG cause a problem while taking ASME stamp by AI.

May you light my mind..
Best Regards.
 
Doesnt the answer to your question lie in your problem definition? "Wihout SA number of reports for HRSG cause a problem while taking ASME stamp by AI.".
I'd say check your AI.
 
Without offending I think you need to talk to your bss or Q.C.manager to clear this, is his/her responsibility to train you so you can do your job right. By Asking the forum you will just learn very little, you need to get to the Code Books and get he answers. Your job is in jeopardy. Regards.

General Blr. CA,USA
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top