Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Sec.9 QW-423 Clarification regarding unasssigned to any pnumber 1

Status
Not open for further replies.

ipi

Petroleum
Joined
Nov 24, 2004
Messages
26
Location
QA
I recently saw a WQT qualified with unassigned to p43 and extend their range of qualification as unassigned to P1 to 15f, 34, 41 to 49.,

As per the table given in QW-423.1 , I understand than any unassigned to any p number qualifies for same p number only, and in this case limited to p43 only.

Your valuable insight regarding the range qualified is welcome

Thanks


 
Your understanding is correct - the WQT is incorrect.
 
Thanks Dekdee.
Much appreciated
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top