Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Maximum Permissible Deviation Fig. UG.80.1

Status
Not open for further replies.
josepmarine

josepmarine

Marine/Ocean
Joined
Oct 28, 2013
Messages
1
Location
ES
Dear friends,

I want to know if exist the tabular values of the figure UG-80.1 from ASME code VIII-1. I am referring to the figure: "Maximum Permissible Deviation from Circular form and for Vessels under external pressure". Is there any book or document with this table?

I would be very useful to program in MS Excel and work faster. Furthermore working with a graph is less accurate than interpolating.

Thank you very much!
 
Status
Not open for further replies.

Similar threads

abangbikerz
  • Question Question
lowest permissible temp for any material
Replies
3
Views
6K
abangbikerz
abangbikerz
C
  • Locked
  • Question Question
ASME VIII-1 Appendix 2 integral flange (Figure 2-4, Sketch 5/6/7) - hub internal to shell boundary permissible?
Replies
12
Views
4K
COpressurepipe
C
milosd
  • Locked
  • Question Question
ASME SB-564 Maximum section thickness for N06625
Replies
1
Views
2K
EdStainless
EdStainless
jayinwww
  • Question Question
Calculating Stress Ratio ASME B31.3 Figure 323.2.2A Note 6
Replies
0
Views
481
jayinwww
jayinwww
T
  • Question Question
Figure 323.2.2-2 (Reduction in Lowest Exemption Temperature for Steels Without Impact Testing) of ASME B31.3
Replies
0
Views
7K
Tommy2025
T

Part and Inventory Search

Sponsor

Back
Top