cdi12
Structural
- Jul 1, 2006
- 38
I am checking something I do not have ASME BTH-1 with me - are all allowable stresses Fy/3 even allowable bearing stress?
Thanks,
IV
Thanks,
IV
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ASME BTH-1 Allowable Stresses 1
- Thread starter cdi12
- Start date
- Status
-
1
- #2
RockEngineer
Structural
The allowable bearing stress between a pin and a plate per ASME BTH-1 eqn 3-51 is 1.25*Fy/Nd. Nd would normally be 3. If your pin rotates a large number of cycles they divide this by 2 for the allowable bearing per eqn 3-52.
- Status
Similar threads
- Locked
- Question
