Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Applying bearing constraints "2"

Status
Not open for further replies.
pm3000

pm3000

Mechanical
Joined
Jul 30, 2011
Messages
1
Location
PL
Hi,
i am trying to applay bearing constraints as in JohnAndrews post in thread828-176845, but get an error: The geometrical references may be in a conflict with another constraint or dependent side of a rigid/weighted link. What am I doing wrong? Constraints were excluded in analysis.
 
Status
Not open for further replies.

Similar threads

BryanAyers
  • Locked
  • Question Question
Creo 9 drawing's tables, "part perimeter", how to setup?
Replies
0
Views
844
BryanAyers
BryanAyers
hkenyon
  • Locked
  • Question Question
Creo 2 simulate lite problems. "MyAnalysis" has already been defined.
Replies
1
Views
809
dgallup
dgallup
tsorel
  • Locked
  • Question Question
"ref_color1" default changed on me
Replies
0
Views
744
tsorel
tsorel
uwpioneer
  • Locked
  • Question Question
PTC Creo- "Unfolding" sheetmetal (Picture included)
Replies
1
Views
838
looslib
looslib
V
CREO Simulate & Simulation Limits / Constraints
Replies
2
Views
11K
Villa
V

Part and Inventory Search

Sponsor

Back
Top