Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Applying an English Thread to a Metric Part in NX 7.5, is it possible?

Status
Not open for further replies.

MASawtell

Computer
Joined
Aug 31, 2010
Messages
334
Location
US
Simple question about NX 7.5 - can some apply a English Measurement Thread (in this case 3/4-16 UNF) to a Metric Measurement NX Model? I understand the ability to show the thread with English Measurements may be nil in Drafting, but I would like to get the Model 'looking right'.
 
Nevermind, I found it in the Thread menu, sorry for asking. [morning]
 
Yes, you can show it as 3/4-16 UNF in drafting, too.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top