Applying an English Thread to a Metric Part in NX 7.5, is it possible?

[MASawtell]

Simple question about NX 7.5 - can some apply a English Measurement Thread (in this case 3/4-16 UNF) to a Metric Measurement NX Model? I understand the ability to show the thread with English Measurements may be nil in Drafting, but I would like to get the Model 'looking right'.

 

[MASawtell]

Nevermind, I found it in the Thread menu, sorry for asking.

 

[looslib]

Yes, you can show it as 3/4-16 UNF in drafting, too.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli