Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Anyone using IMAN instead of INTRLINK for Pro/E objects?

Status
Not open for further replies.

GunnarB

Mechanical
Joined
May 30, 2002
Messages
13
Location
NO
My question is if anyone is using IMAN instead of INTRLINK for Pro/E objects?
What kind of limitations is discovered, if any?

Regards Gunnar
 
Caterpiller

Whenever you use a third-party PDM, you will have a lag when the new version of CAD comes out before the vendor has an updated version of the PDM to support the latest CAD version. (Oh wait, that can even happen if you use Intralink!)


Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top