Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Anyone have problems using the Chamfer Dimensioning tool in Drawing

Status
Not open for further replies.
restaz

restaz

Mechanical
Nov 23, 2005
5
When we try to use the Chamfer Dim. Tool in Drawing,
it gives us a Runtime Exception Error and terminates Catia.
We just started using Catia v5r17sp6
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The only thing I know about the runtime error, is that it happened to me. I believe it was because my computer didn't have the power needed to run the program (RAM, GRAPHICS CARD,HARD DRIVE, ECT). You may need to upgrade your computer before being able to do much with CATIA. Good luck.

Ryan Hill
Design Engineer
bestCADsolutions, Inc.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Sidtha
Get the required proprties from the property window from the bundle segment in catia v5 using vba
Replies
3
Views
6K
crshears
crshears
A
  • Question
DRAWING PROJECTION ANGLE CHANGING
Replies
1
Views
4K
jackk
jackk
Jegsaran
  • Locked
  • Question
Read point coordinates in CATIA using python
Replies
1
Views
1K
LWolf
LWolf
Sriram V
  • Locked
  • Question
Finding Layup location in a tool by comparing surfaces in catia v5
Replies
0
Views
311
Sriram V
Sriram V
JSVKAN
  • Question
Open Drawing sheet and Renumbering
Replies
1
Views
1K
LWolf
LWolf

Part and Inventory Search

Sponsor

Back
Top Bottom