Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ANSYS Workbench in Inventor 2010 Pro
- Thread starter wdb114
- Start date
Inventor 2010 no longer uses ANSYS. Not sure what you mean by, "...not the Pro Menu"?
Are you using Ribbon interface or Classic?
FEA should be under Environments.
I has some problems where it wouldn't show up for me and I still had 2009 installed. I had to to a Clean Uninstall of 2009 and 2010 per Autodesk instructions (including editing of Registry) to get 2010 Pro working correctly. (I was also missing Inventor Studio)
Are you using Ribbon interface or Classic?
FEA should be under Environments.
I has some problems where it wouldn't show up for me and I still had 2009 installed. I had to to a Clean Uninstall of 2009 and 2010 per Autodesk instructions (including editing of Registry) to get 2010 Pro working correctly. (I was also missing Inventor Studio)
- Status
Similar threads
- Locked
- Question