Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inventor 2024 pro: import step issue

Status
Not open for further replies.

o0omirkoo0o

Industrial
Mar 29, 2020
10
Hi everyone.

I'm trying to import a step using open command.

I've tried every single settings available into open dialog box, but i always get the result showed in the attachment.
Parts are greyed out, not visible in 3D area.
How can i fix this?
Thanks for your support :)


 
 https://files.engineering.com/getfile.aspx?folder=ba44e606-c725-47c4-a555-d38f3fdbf4c9&file=import_step_result.png
Replies continue below

Recommended for you

I pulled it into Creo and all of the components were on a layer called '200' and that layer was turned off. Not sure how to explore that in Inventor but I hope that helps.

David
 
Hi.
Yes i did it already and i noticed the same. Problem.is that i dont know how make them visoble without open them one by one into inventor...
🥺
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor