Suppose I need to design an spherically dished vessel head (ASME Appendix 1 Section 1-6) to operate in an ASNI 1500 enviroment (3705 psig). ASME Sec VIII Div 1 rules are valid only to 3000 psig (Section U-1(d)). How do I adapt the design calculations to account for the higher pressure and comply with U-1(d)?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ANSI 1500 Vessel
- Thread starter zakk
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
