Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AMADA LCG 3015 AJ pierce off distance

Status
Not open for further replies.

syedrahimog

Materials
Nov 8, 2018
2
Hello,

Wondering if this is a common LCG 3015 AJ piercing issue. When starting a cut, our laser starts the piercing procedure way over the nozzle gap limit. If the nozzle gap is set to 5 mm, it will start piercing over 25.4 mm. What I've tried is cleaning the nozzle, changing the nozzle, and restarting laser. Nothing has worked. Any thoughts on how to go about this?
 
Replies continue below

Recommended for you

5mm pierce height is way too high my max nozzle gap for pierce is 3mm
 
Problem solved after removing the distance sensor and putting it back in and redoing a head calibration.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor