Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Amada HFA-400W Saw

Status
Not open for further replies.
Rleu

Rleu

Industrial
Joined
Jun 16, 2004
Messages
14
Location
US
I have been dealing with a Amada saw that the rear vise (positioning vise) hunts for position then times out I've replaced the proportional valve with a known good one replaced the encoder all with no luck has anyone had this problem befor

Richard Leu
Cascade engineering and Service
Richard_Leu@hotmail.com
 
Sort by date Sort by votes
I got it it was a sticky contact on the relay board

Richard Leu
Cascade engineering and Service
Richard_Leu@hotmail.com
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

metalbiz
  • Locked
  • Question Question
Amada FO3015 cutting help
Replies
2
Views
1K
Bmehrens97
Bmehrens97
Tom the man
  • Locked
  • Question Question
Amada ITPS brake press
Replies
1
Views
360
MintJulep
M
LaseMe
  • Locked
  • Question Question
Amada aj3015 lcg z sensor wire breaks
Replies
2
Views
988
LaseMe
LaseMe
Jetfalcon1896
  • Locked
  • Question Question
Amada Fo M114222 NT Height sensor issue
Replies
0
Views
492
Jetfalcon1896
Jetfalcon1896
Zecke
  • Locked
  • Question Question
Amada cutting chart
Replies
2
Views
401
Zecke
Zecke

Part and Inventory Search

Sponsor

Back
Top