Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Amada/Fanuc alarm message

Status
Not open for further replies.

fdv99

Mechanical
Jan 22, 2020
5
US
Our Laser had to have the controller power supply swapped out. When we powered on after, it needed a B-axis zero. We started going through the procedure but we have an alarm light and the message "2164 EZ CUT". I can not find any reference to this message in any of our manuals or anywhere online. We can not move any axis in manual or retract modes.
Thank you.
 
Replies continue below

Recommended for you

If I recall EZ Cut is an option. It's a 95% Nitrogen 5% Oxygen mixture Amada once sold back in the CO2 days. Have you tried contacting Amada?
 
The filter for the EZ Cut option has reached the end of its life. Despite the occurrence of this phenomenon, the machine continues to operate until it completes the ongoing process. The alarm message is displayed during this time. Change the filter, and press the ALARM RESET button to clear the alarm.
Or simply reset the EZ cut timer in the Amada Maintenance screen

Prabakaran
Laser Experts India LLP
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top