Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Alternate Layers of Composites and Metals

Status
Not open for further replies.
izax1

izax1

Mechanical
Joined
Jul 10, 2001
Messages
293
Location
NO
Hi all

I have composite layers reinforced with steel for attaching other equipment. Ply1 and the last ply is steel and defined as Isotropic material. All plies in between are composites and defined as orthotropic. When I try to post-process results, I can't get ply results from that particular region. How do I mix Tsai-Wu failure cr. and vMises? Anyone with any Ideas?
Thanks for any hints.
 
Status
Not open for further replies.

Similar threads

NXsupport
  • Locked
  • Question Question
NX: Move objects to Layers journal : Move specific objects to Layers of user choice
Replies
1
Views
3K
jimiherf
jimiherf
MANox
  • Locked
  • Question Question
Number of holes in Hole and thread callout
Replies
0
Views
1K
MANox
MANox
Rene_I-deas_User
  • Locked
  • Question Question
Move Objects to layers
Replies
0
Views
499
Rene_I-deas_User
Rene_I-deas_User
E
  • Question Question
Direction of an Offset Curve
Replies
0
Views
1K
ErkiPerki
E
hmichel
  • Question Question
NX2312 Sketcher and Drafting - Approximate Dimension Symbol
Replies
7
Views
4K
SDETERS
SDETERS

Part and Inventory Search

Sponsor

Back
Top