Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Alteration in OK

Status
Not open for further replies.

robgreg1978

Petroleum
Joined
Sep 19, 2012
Messages
8
Location
US
I have 2 exchangers that I will be replacing a 6" nozzle with a 8" nozzle. This is a NBIC repair job. I have recieved all my design calculations for the alteration. There is not a U-1 for these vessels. There are no data plates on the vessel itself. I have not done much work in Oklahoma but I am being told that I need to get an Oklahoma repair number before I start my repair. I am having no luck with the plant I am in as far as getting the information I need. I have an original Drawing that shows the original thickness and corrosion allowance from 1959. How can I be sure this drawing is for the exchanger that I am working on. There is nothing stamped on the vessel in the field. I am almost at a stand still with this. Everyone refers me to some one else. My AI told me just to document the work i do on the r-2. But I needed to get a repair number from OK. I do not know what information they are going to need from me, besides the fact that I dont have any information. Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top