Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
allowable hole sizes in wall studs & plates
- Thread starter Skicat
- Start date
This is actually located in the IBC/IRC code or you could also look in the Wood Frame Construction Manual.
For the top plate see section R602.6.1
In the IBC the sections are 2308.9.10 and 2308.9.11
Not sure exactly in WFCM but i know it should be there as well.
For the top plate see section R602.6.1
In the IBC the sections are 2308.9.10 and 2308.9.11
Not sure exactly in WFCM but i know it should be there as well.
- Thread starter
- #3
- Status
