Currentely, I'm using "MODELOPT CONC FLAT ELEV BETA" in the aermod.inp. My sfc and pfl files are generated from WRF (using MMIF). I'd like to model the PM10 and PM2.5 in AERMOD. However, when I did tests (using the same emission rate) I got the same values both PM10 and PM2.5. I think could be due to the "CONC" parameter. While we know the PM2.5/PM10 ratio must be less than 1. I would expect to have slightly different values, but not exactly the same. What would be the right MODELOPT configuration to consider the particle size in the horizontal dispersion.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Aermod.inp: I got the same values both PM10 and PM2.5
- Thread starter FOH99
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
