Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Adjust Gap Between Part View and Dimension Line Nx10 1

Status
Not open for further replies.

Nick66

Industrial
Joined
Nov 17, 2014
Messages
42
Location
US
Hello,

Does anyone know how to adjust the spacing between the drafting view and the dimension line in Nx10? In past versions this was done using Preferences->Annotation->Line/Arrow: and adjusting the H and J values. I cannot figure out where to do this in version 10.

Thanks in Advance
 
Great, that is what I needed.

Thanks again Cowski
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top