Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Adding "fin" to a piece of angle

Status
Not open for further replies.
amorrison

amorrison

Mechanical
Joined
Dec 21, 2000
Messages
605
Location
CA

Desire to add a extension fin to 2x2x1/4 6061-T6 aluminum angle.
Butt weld, lateral width say 12 inches, and a 4 to 1 slope(weld 48 inches long).
HAZ with expected to be 0.5 inches on both sudes of the weld.

Any advice or book/reference material on this?
Thanks.
 
Sort by date Sort by votes
Sorry - "sudes" should be "sides".
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

see_gen_notes
  • Locked
  • Question Question
Does a leger angle anchor produce tension AND shear or it tension OR shear?
Replies
11
Views
5K
kingnero
kingnero
P
  • Locked
  • Question Question
Welding a member on top of an existing weld
Replies
7
Views
5K
pinaki_stahlbau
P
SHBhuiyan
  • Locked
  • Question Question
Anlge to Angle weld connection
Replies
2
Views
303
Tmoose
Tmoose
IdanPV
  • Question Question
Welding of S355JR
Replies
1
Views
486
kingnero
kingnero
Tmoose
  • Locked
  • Question Question
Series 1936 SHCS head dimensions 1 1/4"-7
Replies
7
Views
1K
Tmoose
Tmoose

Part and Inventory Search

Sponsor

Back
Top