Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Adaptive coils in IV9?
- Thread starter oliebol
- Start date
Once you have adaptive workplane, create a sketch (for reference only) with line collinear to workplane imprint, add driven dimension from other workplane (where your coil starts), use this dimension in coil dialogue box for length of the coil.
- Thread starter
- #4
1. Create 2 parallel work planes (A, B), make one of them adaptive.
2. Create perpendicular workplane (C).
3. Enter sketch environment, use C for sketch plane, and create imprints of A and B on C using project geometry function.
4. Draw line (D) collinear to the imprint of A, make it construction line.
5. Connect imprint of B and the line with dimension (Driven dimension shall be your only possibility).
6. Still in sketch environment, create construction line perpendicular to D for coil axis.
7. Draw circle for spring wire diameter, make it tangent either to imprint of A or B. The circle shall be between 2 imprints.
8. Dimension as required.
9. Exit sketch.
10. Use coil function, choose the circle for profile and the axis.
11. Go to “coil size” tab, choose “revolution and height” or “pitch and height”, highlight any default height appearing, and click on the driven dimension. Dimension number (dXX) shall appear in the height field.
12. Make other selections as required.
13. Press “OK”.
14. Exit part.
15. Import part in your assembly. Make it adaptive.
16. Constrain both planes A and B as required.
17. When driving your constraints, select “Drive Adaptivity” radio button.
18. It MUST work by now
.
2. Create perpendicular workplane (C).
3. Enter sketch environment, use C for sketch plane, and create imprints of A and B on C using project geometry function.
4. Draw line (D) collinear to the imprint of A, make it construction line.
5. Connect imprint of B and the line with dimension (Driven dimension shall be your only possibility).
6. Still in sketch environment, create construction line perpendicular to D for coil axis.
7. Draw circle for spring wire diameter, make it tangent either to imprint of A or B. The circle shall be between 2 imprints.
8. Dimension as required.
9. Exit sketch.
10. Use coil function, choose the circle for profile and the axis.
11. Go to “coil size” tab, choose “revolution and height” or “pitch and height”, highlight any default height appearing, and click on the driven dimension. Dimension number (dXX) shall appear in the height field.
12. Make other selections as required.
13. Press “OK”.
14. Exit part.
15. Import part in your assembly. Make it adaptive.
16. Constrain both planes A and B as required.
17. When driving your constraints, select “Drive Adaptivity” radio button.
18. It MUST work by now
.- Status
Similar threads
- Locked
- Question