Houjou
Aerospace
- Aug 7, 2014
- 3
Hello everyone,
I am trying to figure out how to do a response spectrum analysis using a frequency vs dB noise spectrum as an input load. After going through the help and googling around, I have not been able to find out how to do that with ANSYS. Do you know of any way to do so?
I am afraid it might not be included in the tools the Workbench offers, so is there any software that you would suggest to do this analysis?
Thank you very much in advance!
I am trying to figure out how to do a response spectrum analysis using a frequency vs dB noise spectrum as an input load. After going through the help and googling around, I have not been able to find out how to do that with ANSYS. Do you know of any way to do so?
I am afraid it might not be included in the tools the Workbench offers, so is there any software that you would suggest to do this analysis?
Thank you very much in advance!