T
tboskos@hotmail.com
Guest
Can anyone tell me, how can I create a knurling feature?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Status
- Thread starter
- #2
L
Lesley
Guest
Diamond or straight??
For diamond see: http://www.proecentral.com/portal/forum/msgDetail.asp?msg_id=2817&for_id=15
For straight, I just use an extruded cut along the shank.
Hope this helps,
Lesley
For diamond see: http://www.proecentral.com/portal/forum/msgDetail.asp?msg_id=2817&for_id=15
For straight, I just use an extruded cut along the shank.
Hope this helps,
Lesley
- Thread starter
- #3
T
tboskos@hotmail.com
Guest
Lesley, I need to create diamon knurling...but i would like to know about straight too
- Thread starter
- #4
L
Lesley
Guest
Beat me to it! I was amending my reply when you replied!
Lesley
Lesley
- Thread starter
- #5
T
tboskos@hotmail.com
Guest
Sorry for replying... somehow I didn`t see your whole answer...thanx lesley
- Thread starter
- #6
L
Lesley
Guest
I was adding the link the diamond knurl section when you replied, so don't worry about it! 
Lesley
Lesley
- Status
Similar threads
- Locked
- Question
- Locked
- Question