Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

A350 Flanges for Valves

Status
Not open for further replies.
mascar

mascar

Materials
Joined
Aug 14, 2007
Messages
2
Location
IT
Hi all.
I have a question about A350 standard for flanges.
Is it possible to obtain a flanged valve by machining a forged round bar? This because A350 standard (par.4.3.3) tells that just flanges could not be obtained in this way.


Thanks for your answers.
 
Status
Not open for further replies.

Similar threads

Christian Dimitrov
  • Locked
  • Question Question
Forged flanges in A182 F347
Replies
7
Views
1K
EdStainless
EdStainless
G
  • Locked
When I looked at the specification ASTM C33 I did not find the specification limits for the 1/2-inch sieve as mentioned in the
Replies
0
Views
1K
GHADA ALQARESH
G
Muza33
  • Locked
  • Question Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
740
Muza33
Muza33
Rizkyffq
  • Locked
  • Question Question
[ASK] Standard in ASTM that Provides Info Requirement Only for Hardness Value for Alloy Steel ?
Replies
3
Views
498
EdStainless
EdStainless
Surchi
  • Locked
  • Question Question
How do we check Hardness values for
Replies
3
Views
304
Surchi
Surchi

Part and Inventory Search

Sponsor

Back
Top