Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

A325 VS A320 for low temperature application

Status
Not open for further replies.
laquinnia

laquinnia

Structural
Joined
Dec 20, 2007
Messages
2
Location
US
I have a "low" temperature application for structural steel. The design temperature is about -60F. Are A325 bolts suitable at this temperature or must I go to A320 bolts?
 
Sort by date Sort by votes
This is considered low temperature service, and I would use A 320 material.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mrmalcolm
  • Locked
  • Question Question
Definition of application temperatures in ISO 15614-1
Replies
3
Views
2K
SJones
SJones
infometrix
  • Locked
  • Question Question
Reducing the thickness by machining to qualify for low thickness pipe WPS
Replies
5
Views
920
infometrix
infometrix
Welding Engineer
  • Locked
Maximum Preheat Temperature in Power Piping
Replies
3
Views
3K
DekDee
DekDee
Cormet
  • Question Question
Minimum PWHT cycles for piping
Replies
0
Views
1K
Cormet
Cormet
sdra2
  • Question Question
Weld assessment for lifting beam
Replies
0
Views
3K
sdra2
sdra2

Part and Inventory Search

Sponsor

Back
Top