Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

A client wants to bend a DN 225 pla

Status
Not open for further replies.
stanier

stanier

Mechanical
Joined
May 20, 2001
Messages
2,442
Location
AU
A client wants to bend a DN 225 plastic pipe in a 10 m radius. How do I find the stresses in the pipe wall arising from the bending process? What would be the loads at supports spaced every 2000mm?
Sharing knowledge is a way to immortality
 
Status
Not open for further replies.

Similar threads

K
  • Locked
  • Question Question
DN 165
Replies
4
Views
3K
KevinNZ
KevinNZ
jwpyr8
  • Question Question
Using a backpressure regulator to maintain a minimum pressure
Replies
18
Views
2K
jhnblgr
jhnblgr
N
  • Question Question
How to properly analyze a flange at a boiler in stress analysis?
Replies
5
Views
695
Snickster
Snickster
H_Haroun
  • Locked
90° 5D stainless steel Bend
Replies
6
Views
3K
johnnymeng2025
J
nitin badhane
  • Locked
Transverse crack developed on induction bend
Replies
3
Views
2K
r6155
r6155

Part and Inventory Search

Sponsor

Back
Top