Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3D sketch and workplanes

  • Thread starter Thread starter Canon
  • Start date Start date
C

Canon

Guest
Is there a way to add workpoints/workplanes on a 3d line made from two intersecting extruded surfaces?
 
Normal to Path workplane: Workplane tool->pick the 3D line and pick one of
the end points on the 3D line. You can pick any point to place a workpoint.
 
You must log in or register to reply here.

Similar threads

duk748
  • Locked
  • Question Question
exporting an inventor sketch to autocad
Replies
1
Views
1K
looslib
looslib
kevc70
  • Locked
  • Question Question
Saving Title Block and Border in AutoCad Inventor
Replies
1
Views
445
TuanTH
TuanTH
C
Create and Share 3D Interactive Assembly Instructions Using cadasio
Replies
2
Views
9K
Cadasio
C
E
Why the Tube and Pipe fittings at Content Center doesn't have iMates?
Replies
0
Views
6K
EdsonPaschoal
E
P
Problem with snapping in part sketch
Replies
0
Views
9K
PanSam
P

Part and Inventory Search

Sponsor

Back
Top