3D piping drawing command

[chicopee]

I seem to remember an easy way of laying out piping in 3D however I forgot the command. The procedure was to draw the center line and then draw a circle on one end of the center line and invoke this "forgotten" command to have the circle extrude itself to follow the centerline.

 

[CarlB]

"forgotten" command to have the circle extrude itself

 

[chicopee]

Carl B- it is not extrude. This "forgotten" command will follow a path such as a center line that may have bends. The Extrude command will not bend.

 

[IFRs]

Sure it will. Extrude [pick circle] Path [pick path]

 

[chicopee]

Thanks You responders- somehow I forgot about the PATH option