Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3D Induction bends

Status
Not open for further replies.

Harshu03

Materials
Joined
Dec 16, 2019
Messages
7
Location
GB
Are the test bends to qualify MPS as per ISO15590-1 produced at the same angle that of production bends..

We have a problem of 3D bend produced out of tolerance of mentioned bend angle per requirement however the test bends for MPS were tested at different angles that of production bends.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top