pnavy
Mechanical
- Feb 5, 2014
- 19
Hello,
I am new on NX 7.5 and I have a bit of truble to get a nice surface to make a cut on a solid.
my surface end was irregular so I trimmed it with plane and now I would like to extend the "trimmer curbe" but according to bottom extension that goes 3D.
So is this possible?
Many thanks
and pic.
I am new on NX 7.5 and I have a bit of truble to get a nice surface to make a cut on a solid.
my surface end was irregular so I trimmed it with plane and now I would like to extend the "trimmer curbe" but according to bottom extension that goes 3D.
So is this possible?
Many thanks
and pic.