How do you create a 3d cross section in a drawing, i.e. a view that is ISO. I have failed so far and the only way I can think to do it is to create a cut through half of the part, and blank it off in other views, this is messy and has the potential for disaster!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
3D CROSS SECTION
- Thread starter swalton44
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question