Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
3d coordinates
- Thread starter jasonnl
- Start date
The task is a manual one. If you have a default cs, and have many other cs's offset from the deafult one, then in the drawing table, enter the &d# for the x,y,z-offset dims.
Now if your cs's are created with such options as "3-Planes", then you have a harder time to show these values because the planes drive the position of the cs.
Steve
Now if your cs's are created with such options as "3-Planes", then you have a harder time to show these values because the planes drive the position of the cs.
Steve
- Status