Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
3D and 5D elbows
- Thread starter KevinNZ
- Start date
STYMIEDPIPER
Mechanical
look at BendTec, Inc
Duluth Minnesota
There are a few good pipe shops with bending capabilities. You most likely will not locate 'shelf' item for sizes you listed (24 & 36 nps).
Duluth Minnesota
There are a few good pipe shops with bending capabilities. You most likely will not locate 'shelf' item for sizes you listed (24 & 36 nps).
Once upon a time, I tried to locate a 48" forged ell, finally got a price, only to find out they were figuring a segmented ell made to forged ell dimensions. Make sure what is being quoted.
You might also check with Tulsa Tubebending- I don't know if they go that big, though.
You might also check with Tulsa Tubebending- I don't know if they go that big, though.
- Status
Similar threads
- Question
- Question
- Question