M
mpaknia
Guest
Does anybody uses 2Danalysis in Pro/M, if not why?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Status
- Thread starter
- #2
I
Israr
Guest
yes we do.
depends on the case study. For example you can solve all the problems of the book "Strength of Materials" by Singer .
Israr
depends on the case study. For example you can solve all the problems of the book "Strength of Materials" by Singer .
Israr
- Thread starter
- #3
L
Luis Aguirre
Guest
There are alots of reaons why one should used 2D analysis whenever is possible. I our case we use it to optimize the desing using the MECHANICA optimize tool.
Luis
Luis
- Thread starter
- #4
M
mpaknia
Guest
- Thread starter
- #5
S
sezerserhan
Guest
I never needed to simplify my models to 2D while using pro/mechanica. It somehow even complicates the situation if you are working with unusual problems.
- Status