Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
2 roll plotting
- Thread starter bbylls
- Start date
Arkance/PhoeNX
Mechanical
Are you plotting to it from NX at the moment?
If you are, then you need to go into the Print Administrator and edit the Model you are using.
You then specify the two different rolls and for each roll create an initialisation file that has the codes your plotter needs to specify the roll to use.
Anthony Galante
Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.2, NX10 Beta
If you are, then you need to go into the Print Administrator and edit the Model you are using.
You then specify the two different rolls and for each roll create an initialisation file that has the codes your plotter needs to specify the roll to use.
Anthony Galante
Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.2, NX10 Beta
- Status
Similar threads
- Locked
- Question