Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

2 decals on same surface

  • Thread starter Thread starter ilmegor
  • Start date Start date
I

ilmegor

Guest
Is it possible to place 2 different decals on the same surface of a part? How to do it?


Thanks
 
Can you not merge the decals prior in some Corel or Photoshop prior to applying?
 
You could create 2 fill surfaces that lay on that surface andadd the decals to them. Not what you wanted to here but will work.


Krow72
 
Fills will only work for flat surfaces. What if you surface isn't flat? I suppose you could copy the surface and then trim as many times as you need but this may be tedious and you may need to offset the surfaces a very small amount (say 0.05mm) to stop the interference of colours that occurs when two surfaces coincide.
 

Part and Inventory Search

Sponsor

Back
Top