Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1045 Cold Drawn Endurance Limit

Status
Not open for further replies.
Penguineer

Penguineer

Mechanical
Joined
May 31, 2012
Messages
21
Location
US
Hello All - I have been searching for the endurance limit of 1045 cold-drawn steel bar but have thus far been unsuccessful. Does anyone know where I can search or have a source I could reference to get this value? Thank you.
 
Sort by date Sort by votes
I think your best bet will be to use the typical approximation of 1/2 UTS as high cycle fatigue strength. Good Luck otherwise.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

b_unruhly
  • Locked
  • Question Question
1215 Hot Rolled vs Cold Rolled
Replies
19
Views
1K
mfgenggear
mfgenggear
rollingcloud
  • Locked
  • Question Question
Procurement spec for 304 ss cold worked bar, ~34 - 39 HRC
Replies
11
Views
1K
EdStainless
EdStainless
David Maijala
  • Locked
  • Question Question
Cold forming AL alloy in W or AQ condition
Replies
4
Views
492
MagBen
MagBen
Channo
  • Locked
  • Question Question
Max. Limit to Harden a steel
Replies
13
Views
858
FacEngrPE
FacEngrPE
Laboratorio TRF
  • Locked
  • Question Question
Out-of-range ultimate tensile strength (UTS) of a cold-drawn 304 tube.
Replies
4
Views
302
Laboratorio TRF
Laboratorio TRF

Part and Inventory Search

Sponsor

Back
Top