Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1/4 box symmetry constraint error

  • Thread starter Thread starter alfordtp
  • Start date Start date
Status
Not open for further replies.
A

alfordtp

Guest
I have a box that I modeled only 1/4 of it for the analysis.
There are many weldsin the supports in the assembly. If I free up
the translations in the plane of the cut, it gives me an error trying
to delete the constraints. Because it is 1/4 of the model, I have
this on both the top and the side.



Anyone know why? I have a pic that I can send to anyone wanting to look at it.



Thanks,



Tim




2005-06-22_095933_initialtest.zip
Edited by: alfordtp
 
what version of Pro are you using?
 
from help (WF2.0)
<H1>
<H1>Symmetry Constraints</H1>


Use the Insert>Symmetry Constraint command in Structure or Thermal to create a cyclic or mirror symmetry constraint. This command is not available in FEM mode. When you select this command, the Symmetry Constraint dialog box appears with these items:
<UL>
<LI =kadov-p>


Name
 
I thought it was that easy, but that is where it is giving me
errors. When I put in the symmetry constraint just like that,
Wildfire 2.0 tries to delete the constraints.



thanks though...
 
Could it be that you are applying sutrface constraints and using shell
idealizations at the same time!! If that's the case, ProM will delete
the constraints because the constrained surfaces will not exist after
the shell compression takes place. You'll need edge/line constraints
instead.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top