Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

-044 static face seal

Status
Not open for further replies.

pedrof

Mechanical
Joined
Oct 19, 2004
Messages
56
Location
US
I am specifying a low pressure oring, it is going to high temp so we are using Kalrez.
I have gone through the Parker o-ring guide and the dims for the groove/gland for the -044 oring are coming out at
Groove OD 3.879 +0.000/-0.002, groove width 0.101 to 0.107, depth at 0.050 to 0.054.
Firstly, do these dims look correct? Secondly, using High temps (230°C) should these be adjusted slightly for extra expansion.
Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top