Sketch dimensions in V15, I place in Part, do not show up unless I move the cursor over them. The lines and arrow heads show in black, with a gap where the number should be.
I.e. |<--- Blank --->|
Have I switched something off inadvertently?
Tony
We have a product which we are currently machining from sheets of eva. The next stage is a limited moulding run to test the market.
I know very little about moulding eva and would like some information and guidance.
Thanks Tony
Often when designing, I need a simple 3D mannequin with basic joint movement, ankles, knees, hips, wrists, elbows, shoulders and head, that’s scalable. Can anyone suggest a simple inexpensive software program to do this.
Tony
I have purchased 2nd hand a Vacuum Pump, which I intend to use on a Vacuum Table for machining rubber. The inlet (the sucking pipe) is about 1" dia. and has only a corse mesh filter. I intend to make a better filter for swarf and rubber particles, but am unsure as to what material to use for...
"The How and Why of Mechanical Movement - Harry Walton" is a Popular Science Book, Copyright 1968 and is similar to Mechanisms & Mechanical Devices, I got mine second hand at Amazon, very simply written, but a lot of basic information.
Tony R
Thank you for that John, as the program saves a data text file every 10 mins, shutting it down or rebooting would not be a problem. I'll write a test program and tryout all your suggestions.
Tony
I have a computer running Win98 monitoring a testing machine. The readings are via the parallel port using a Pico adaptor and VB5. The 3.3v from the parallel port via a transistor and 2 relays (one is latching), switch the machine motor. The idea is, that on completion of the test or if the...
Thank you all for your help, I may purchase a TV-B-Gone and record the codes. There must be a few, if it takes over a minute to go through them all.
Tony R
I am in the process of designing a machine, one of the functions of which, is to switch of the television by emitting an "off" remote control code. I realise that each brand of television has a different code.
Is there a universal "off" code?
Where can I obtain a list of "off" codes?
Tony R
I have a test apparatus to make which uses 12mm plough ground mild steel plates. The current apparatus they have gets an unsightly covering of light rust when not being used, I have suggested a dewatering fluid such as CRC, but this picks up dust.
The apparatus is inside a laboratory building...
I have an application requiring 120 l/m (4.25 ft3/min) of air at 10 kpa (1.5 psi) and I need to power it from 12v DC, 10A max. The project is in prototype stage and I will probably make a unit to test the idea.
Whilst I know how side channel blowers work, I have no idea how to calculate the...
I have an application requiring 120 l/m (4.25 ft3/min) at 10 kpa (1.5 psi) and I need to power it from 12v DC, 10A max. The project is in prototype stage and I will probably make a unit to test the idea. Whilst I know how side channel blowers work, I have no idea how to size the components...
I have recently been asked to design and make a machine for the production of “Bath Bombs”. These are perfumed foaming blocks that are used in spas and baths.
The ingredients (consisting mainly of Epsom salts) are mixed dry and a very small amount of water is added. They can be pressed into...
I have a Combo Box and am using AddItem after the text is replaced/edited. After Enter is pressed I want the focus to then move to the Text Box below, so this entry can also be edited/replaced.
It has defeated me! Please experts help me.
Tony
