By the way, Re: Flashing Dimension: Min. As Reqd.
Different contractors may interpret minimum dimensions differently. A roofing contractor often prefers to have more room to flash than some other trade contractor who's interest is minimizing his labor and material thinks is necessary...
1. By IMP, do you mean Insulated Metal Panel?
2. What is the crush resistance strength of the duct?
3. As an aside, if known, what is the gauge of the metal and the thickness of the insulation?
4. How about placing a piece of sheet metal wider than the hold down strap under the strap to...
Hi,
Thanks for the comments. The notifications of the replies went into my spam folder so I just found them.
After I posted I found a little sticker on the bolt (which I had bought some time earlier at Home Depot I think, that indicated the working load was 300#. So that's fine. I don't...
I have an application where I want to use a 1/2" folded eye bolt to support a load of 300 lbs with a safety factor of 3x.
Without doing any calculations, intuitively I'm sure a 1/2" folded eye bold can easily hold 300 lbs and has an ultimate breaking point somewhere north of 900 lbs. I plan...
how do I verify calendar is OK? What is effort? I verified all holidays and weekends are in white (working days.) Work is every day.
Whats the next thing that comes to your mind?
1. I have subtasks that are supposed to last 7 days each and you have to finish one to start the next. I have entered actual start and finish dates on the tasks completed so far. They all took longer than 7 days. Durations are being generated that seem to make no sense in relation to...
Under Task Infomation/General, my tasks all seem to have a Priority of 500. I didn't set it to that.
- What is Priority?
and
- Why do my tasks show 500 when I didn't specify anything?
I looked up "priority" in Help and it didn't return a topic with that in the title.
Hi,
How can I change decimal points in Duration? It is now showing me Duration in days to 2 decimal point accuracy. I would like it to show in days rounded to the nearest day (no decimal points.)
What size and gauge should metal studs be for a residential sheet rock ceiling in a kitchen that is 10' x 12'? What is the proper thickness of sheet rock? =TB
The light I want to use is a High Pressure Sodium lamp, which is about as efficient as lights get. I don't want to use flourescent as they do not put out enough light in a point source.
