FacEngrPE
Design is 325F and Operating is 41F.
Operation is continuous and will be @ 41F most if not all of the time.
Good point, but I do not have any concerns about the fitting above the flat bottom counterbore.
SnTMan
The uncertainty of those design reviews is what makes it exciting! Haha
KevinNZ
Are you referring to B31 case 202, reinforcement of a tee? If so, Ive worked with those calcs in recent years for another product and I am not seeing how that would apply here.
Can you explain a little...
SnTMan
I totally agree. Being creative with the texts is essential. Depending on the audience, however, it can get hairy.
In this case, I am putting together a package that will be used to register the design in Canada (CRN).
Most importantly, I need to satisfy myself, ensuring I am confident in...
The product is a turbine meter, essentially a 10" Sch 80s 600# Pipe Spool.
The "Blind Counterbore" is a counterbore that only penetrates the pipe partially from the outside.
This counterbore is fitted with a sensor that magnetically senses a spinning rotor inside.
The thickness under the...
SnTMan
Unfortunately, the Sect 32-5 required blending between the LTA and thicker section is something I cannot comply with :(
It was a good read though and something I was not aware of. Thank you!
I'll continue to study it a bit though.
Before I proceed with burst or FEA proofing, I wanted to see if anyone is aware of any methodology or equations that cover this situation in ASME.
My wall thickness under a blind counterbore is insufficient when run through a basic minimum wall thickness calc for pipe.
Ive reviewed B31 standards...
90 degree forged WYE 2" Sch 40S F317SS
Design Calculations to be provided with product
800psig @300F
I was offered a block style for $4500
And fully outer contoured machined for $7500
That is each!
And I am buying 20+ of these so that price is not going to work for me.
I was just quoted $400...
Maybe I do not have enough experience with code cases but I am really surprised by the amount of detail and work the committee has provided in this code case #202.
I am getting wildly different quote values on the forged 317 SS 2" WYE.
Ranging from $400 to $7500.
Still trying to figure out what...
Guys please help direct me.
We are remaking an old B31.1 pipe section that had the following configuration on the sampling tap.
90 degree welded WYE 2" Sch 40S 317SS (made from 3 pipes)
welded to
4" Sch40S 317SS Header pipe.
I am good with the Header and Branch Min wall thickness and...
I have experienced the same issue. I am interested in processes used or comments in this area also. I have attached a to scale code slip on process and result. This would be a worst case scenario for...
