Recent content by innov

just opening Logitech setpoint once usually resolves that problem. It may have something to do with the 'smooth scrolling' feature in Chrome?

I also have the extra buttons on my mouse assigned to the 's' key and 'Enter'...

I have tried changing those settings. They do work while not isolating components, but as soon as I start isolating pieces, the setting seem to have no effect. Thank you for your reply

Thanks for your reply. I am able to make the whole assembly transparent, which is not what I want. I want all parts except the one being edited to be transparent.

When editing a part in the context of an assembly, all other parts change to the transparent state I set in "Options". However, if I Isolate several components and then edit a part, I cannot get the other pieces to change transparency. What's up with that? Thank you SW2007, SP 3.1 Intel Core 2...

sorry for not getting back sooner...I'm using a Cordless Desktop MX3000, the mouse is an MX600. I had to disable the side-scrolling option, as it clicks easier than the center button. I programmed the handiest one for 'Enter'. It's unbelievable how often that gets used, not only in SW, but any...

I assigned buttons on my mouse to such tasks as (inserting new sketches), extruding, and so on. you have setup a keyboard shortcut (if none already exists) and then assign the buttons to simulate the keypress

Mirisola (Mechanical) 22 Mar 07 22:01 Just because you mentioned it, holding down the middle button + ctrl will allow you to pan... IF the scroll button is setup as (middle button). I'm using a Logitech mouse, and the scroll button came assigned as (alternate scroll), or something to that...

I think I'd vote for integrating SolidMap. I saw it the first time just recently, and seems a no-brainer. I've been wishing for just something like it, but for $8000 I certainly can't jump for it.

Thanks for the reply, Jeff I just reread your message...the assemblies I work with (around 10-30 parts) do have a lot of inter-dependent sketches, and each part will roll back to the first feature with an error, which is usually caused when I edit a part in the assembly. A lot of times when...

where did the de-sta-co products go to??!! I can't find them anymore!!

Yes I do have the 64 bit hardware, and dual-core. I'll try upgrading to the next SP, see if that'll make a difference. I had thought there was a checkbox to set the option...I guess I was mistaken

been answered before, check this out http://www.eng-tips.com/viewthread.cfm?qid=151300

Hi all, When rebuilding an assembly with errors, each individual part rolls back to the feature with the error, causing errors in other dependant parts. I've searched help for some kind of setting to change, and was unable to come up with anything. I'm running SW 07 SP0.0 on a 64 bit sys. this...

MX 3000 Cordless desktop MX 600 1 2 3 Middle Button 4 Pan 5 Enter (you get quite attached to this one, it does everything. Almost.) 6 do nothing (so I don't inadvertantly press it) or middle button 7 do nothing (so I don't inadvertantly press it) or middle button 8 9 10...