We are looking to install four flowmeters on the following application, has anyone any advise or reccomendations based upon previous experience of similar applications,
Product Demineralised water
Temperature ambient
Pressure 4 bar
flow rates required 68 m3/hr, 60 m3/hr, 54 m3/hr and 13 m3/hr...
We are looking to replace a ph system that has three sensors ( triple validation ) on the suction side of a self priming pump. We have to replace the sensors due to drying out problems. for various operational reasons it will be difficult to re engineer the pipe work.
Any tips or advise on this...
Many thanks Saxon
This was my first port of call, I was looking for a more indipendant view which I have received from JMW.Once again thanks for everyones contributions which have been extremely useful.
Regards
Bill
Many thanks jMW.
In answer to your question the equipment in question is now obsolete. for the sake of brevity I will list the main points that may help.
1) The existing equipment is obsolete
2) We are looking to replace the current system i.e. the coriolis instrument that measures the density...
JMW
Many thanks this is an excellent reply,
I have had conflicting advise from manufacturers, this has made it difficult to select the correct system. The system that I am looking to utilise is very similar to your description in your paragraph five i.e. single density meter, static mixer. The...
Peter,
Not quite what I was looking for, this was probably down to my inaccurate description. the system that we have installed at the moment has the following . In line three way control valve, in line mixer, in line mass flow meter and controller.
The water is pumped to the inlet of the...
We are looking to replace a coriolis mass flowmeter, three way control valve and process controller. The system requires the accurate control and mixing of water and Sodium hydroxide from 47% to 23% for site distribution. has anyone experience of good quality equipment that can be used for this...
Your assumptions are correct the air is used for critical service. the dew point is minus 40 C @ 4.4 bar.The dessicant is Mobil Sorbead.
Once again many thanks for your reply which has been very helpful.
Regards
Bill
My suggestion would be. Cameron Hydraulic Data Handbook
Subjects covered
Hydraulic principles
Friction Data
liquids density, SG, vapour pressure, viscocity etc
steam data
electrical data
formulae
pump selection guide
Regards
Bill
Can anyone give me a Basic explanation of the difference between a heatless adsorption dryer and a heat generated dryer. I do stress basic!!
Many thanks
Bill
Can anyone help. I am trying to locate Contronic developments ab. I believe that they are based in Sweden. the products that I need are ph probes manufacturered bt Contronic.
Many thanks
Bill
