Search results for query: *

We are looking to install four flowmeters on the following application, has anyone any advise or reccomendations based upon previous experience of similar applications, Product Demineralised water Temperature ambient Pressure 4 bar flow rates required 68 m3/hr, 60 m3/hr, 54 m3/hr and 13 m3/hr...

We are looking to replace a ph system that has three sensors ( triple validation ) on the suction side of a self priming pump. We have to replace the sensors due to drying out problems. for various operational reasons it will be difficult to re engineer the pipe work. Any tips or advise on this...

Many thanks Saxon This was my first port of call, I was looking for a more indipendant view which I have received from JMW.Once again thanks for everyones contributions which have been extremely useful. Regards Bill

Many thanks jMW. In answer to your question the equipment in question is now obsolete. for the sake of brevity I will list the main points that may help. 1) The existing equipment is obsolete 2) We are looking to replace the current system i.e. the coriolis instrument that measures the density...

JMW Many thanks this is an excellent reply, I have had conflicting advise from manufacturers, this has made it difficult to select the correct system. The system that I am looking to utilise is very similar to your description in your paragraph five i.e. single density meter, static mixer. The...

Peter, Not quite what I was looking for, this was probably down to my inaccurate description. the system that we have installed at the moment has the following . In line three way control valve, in line mixer, in line mass flow meter and controller. The water is pumped to the inlet of the...

We are looking to replace a coriolis mass flowmeter, three way control valve and process controller. The system requires the accurate control and mixing of water and Sodium hydroxide from 47% to 23% for site distribution. has anyone experience of good quality equipment that can be used for this...

Your assumptions are correct the air is used for critical service. the dew point is minus 40 C @ 4.4 bar.The dessicant is Mobil Sorbead. Once again many thanks for your reply which has been very helpful. Regards Bill

My suggestion would be. Cameron Hydraulic Data Handbook Subjects covered Hydraulic principles Friction Data liquids density, SG, vapour pressure, viscocity etc steam data electrical data formulae pump selection guide Regards Bill

Many thanks Art we are considering replacing a unit that uses steam as the heat source. does this make sense? Bill

Can anyone give me a Basic explanation of the difference between a heatless adsorption dryer and a heat generated dryer. I do stress basic!! Many thanks Bill

Many thanks Bchoate, I have found a company( Achromatic ) in Scotland that distributes the PH probes that we needed. Regards Bill

Can anyone help. I am trying to locate Contronic developments ab. I believe that they are based in Sweden. the products that I need are ph probes manufacturered bt Contronic. Many thanks Bill

Could you please advise on where in the UK I could purchase a copy of ASME B31.3 Many thanks

Any advise on where to purchase ASME B31.3 in the UK.

could you help me to find a valve supplier in the UK or europe for 8 x 6" gate valves butt weld ends schedule 40 for use on LNG @ 10 bar temp minus 165 centigrade

As a supplier of materials we have occasional problems with manufacturers 3.1.b certification. the cast or heat number on the cert is not always stamped on the goods. should these goods be returned for stamping? can we stamp the goods with the manufacturers agreement ? Is there a document...