Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plastics Engineering general discussion

darshan84
  • Locked
  • Question Question
Plastic Resin
Replies
2
Views
215
Dee87
Dee87
R.H
  • Locked
  • Question Question
PVC contaminated with POM "DANGEROUS" !!!
Replies
4
Views
644
Demon3
Demon3
ezgotextronvdr
  • Locked
  • Question Question
Extreme Mold Lock - Expert Input Needed
Replies
7
Views
327
Pud
Pud
ThreadDesign
  • Locked
  • Question Question
Plastic Thread Failure
Replies
3
Views
530
ThreadDesign
ThreadDesign
Graeme Allison
  • Locked
  • Question Question
Injection moulding question
Replies
1
Views
251
MacGyverS2000
MacGyverS2000
Marc_Bloke
  • Locked
  • Question Question
Injection Moulding Quote Calculations
Replies
16
Views
2K
MikeHalloran
MikeHalloran
bljnv
  • Locked
  • Question Question
Brass plastic combination parts
Replies
0
Views
171
bljnv
bljnv
goldenfab
  • Locked
  • Question Question
TPU Boot Cover Interference Fit
Replies
4
Views
615
btrueblood
btrueblood
donnie montana
  • Locked
  • Question Question
Can a hip flask for alcohol be made from hard plastic?
Replies
1
Views
283
Pud
Pud
waross
  • Locked
  • Question Question
PVC vs. CPVC
Replies
3
Views
369
Pud
Pud
DaiLG
  • Locked
  • Question Question
Screw boss thread stripped during screwing operation
Replies
8
Views
672
Compositepro
Compositepro
irfansiddiqui
  • Locked
  • Question Question
Plastic recycling material issues
Replies
0
Views
158
irfansiddiqui
irfansiddiqui
emoraniec
  • Locked
  • Question Question
Cost effective mold blowing solution
Replies
2
Views
199
3DDave
3DDave
drodrig
  • Locked
  • Question Question
Suitable plastic for -40º, low CTE and isopropanol resistant
Replies
3
Views
269
btrueblood
btrueblood
Joseph Roberts
  • Locked
  • Question Question
PEI plate out on diamond turned insert for lens molding
Replies
0
Views
143
Joseph Roberts
Joseph Roberts
TimBow123
  • Locked
  • Question Question
Plastic Threads - Quality Requirements
Replies
2
Views
346
TimBow123
TimBow123
ian321
  • Locked
  • Question Question
Plastics Eating Worms
Replies
1
Views
211
MacGyverS2000
MacGyverS2000
W205
  • Locked
  • Question Question
Thin machine cover made from light and shape stable material
Replies
12
Views
544
RPstress
RPstress
Tec17
  • Locked
  • Question Question
warpage with sunlight/heat
Replies
0
Views
127
Tec17
Tec17
MacGyverS2000
  • Locked
  • Question Question
Ultrasonic knife
Replies
0
Views
189
MacGyverS2000
MacGyverS2000
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top