Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Metal and Metallurgy engineering

tydguy
  • Locked
  • Question Question
Ultimate Tensile Strength doesn't equal F/A?
Replies
15
Views
590
realtime2
realtime2
Andy Lacey
  • Locked
  • Question Question
Hydraulic cropping machine blade materail
Replies
0
Views
64
Andy Lacey
Andy Lacey
1366060
  • Locked
  • Question Question
Shaft Heat Treatment
Replies
7
Views
710
1366060
1366060
curious_eng
  • Locked
  • Question Question
AISI 410 SS lateral expansion
2
Replies
21
Views
915
MagBen
MagBen
AnnyB
  • Locked
  • Question Question
Impact toughness of 17/4PH versus thickness
Replies
3
Views
166
MagBen
MagBen
cjohnso0
  • Locked
  • Question Question
TTT Diagram for Waspaloy
Replies
5
Views
469
MagBen
MagBen
Arshad Ahamed
  • Locked
  • Question Question
The logic behind SAE Steel Nomenclature.
Replies
5
Views
570
MagBen
MagBen
AnnyB
  • Locked
  • Question Question
Charpy impact toughness criterion
Replies
2
Views
314
AnnyB
AnnyB
demsha
  • Locked
  • Question Question
UT crawler inspection of Duplex steel surfaces
Replies
1
Views
110
EdStainless
EdStainless
Erkamal
  • Locked
  • Question Question
Impact test on Tungsten carbide material .
Replies
2
Views
440
IRstuff
IRstuff
newbies022014
  • Locked
  • Question Question
Pin S45C broken
Replies
3
Views
129
dbooker630
dbooker630
Superslinky
  • Locked
  • Question Question
Fe/AC8 Plating Cross Reference?
Replies
0
Views
237
Superslinky
Superslinky
capntom62
  • Locked
  • Question Question
17-4 Annealed vs H1100
Replies
3
Views
360
shu60
shu60
trainguy
  • Locked
  • Question Question
Notch toughness and how to address it
Replies
9
Views
323
EdStainless
EdStainless
Dyskolos
  • Locked
  • Question Question
Nitronic 50 HS stress relief?
Replies
5
Views
431
shu60
shu60
AnsAvi
  • Locked
  • Question Question
Reason why the SEMI F20 standard puts a limit to the grain size of SS
Replies
4
Views
322
AnsAvi
AnsAvi
MechatroPro
  • Locked
  • Question Question
texture on stainless casting parts after lathing
Replies
10
Views
463
Maui
Maui
reddy3
  • Locked
  • Question Question
In Reference to the thread Proof st
Replies
2
Views
205
metengr
metengr
jtowne
  • Locked
  • Question Question
Soldering FM Brass
Replies
3
Views
289
-
?
alanisphoenix
  • Locked
  • Question Question
grade 3 ASTM A333
Replies
9
Views
307
alanisphoenix
alanisphoenix
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top